Fluke 752A Reference Divider
- Precision 10:1 and 100:1 dividers primarily designed for comparing direct voltage levels to a 10V voltage reference standard.
- Internal switching allows for calibration of different voltage ranges with a 10V standard without the need to change connections.
- Self-calibration procedures enable compensation for long-term changes in the value of the divider resistors by switching their positions in various Wheatstone bridge configurations
Fluke 5790B AC Measurement Standard
- Absolute AC voltage measurement uncertainties as low as ± 24 ppm (one year, 23 °C ± 5 °C).
- Alternating voltage range of 600 μV to 1000 V, and a frequency range of 10 Hz to 1 MHz, with options to extend to 30 or 50 MHz.
- Combine with A40B Current Shunts for direct, absolute, or relative current measurements without the need for calculations.
- 6.5-inch, full-color, capacitive touch screen display.
Fluke 792A AC/DC Transfer Standard
- Ultra-high accuracy AC/DC Thermal Transfer Standard with uncertainties as low as ±10 ppm (±5 ppm from NIST).
- 2 mV to 1000V voltage range, 10 Hz to 1 MHz frequency range
- Features a Fluke Calibration solid-state RMS sensor for temperature stability and fast settling time; measurements made in as short as 30 seconds.
- The 792A consists of four units including a Transfer Unit, a Power Pack unit, a 1000V Range Resistor and a Transfer Switch, and is shipped from the factory traceable to national standards with a table of correction factors and uncertainties.
Fluke 742A Resistance Standards
- High-accuracy working standards for on-site resistance calibration.
- Small, rugged, and easy to transport.
- Temperature stability and six-month stability to 2.5 ppm.
- Temperature range: 18°C to 28°C.
Fluke 908/909 Frequency References
- Designed for calibration laboratories, ideal for calibrating a wide range of instruments, offering excellent short-term stability for faster frequency calibration.
- Serve as an accurate ""Atomic clock"" reference in automated test systems.
- Fast warm-up time, increasing productivity and efficiency in calibration tasks.
- Cost-effective solution for frequency standards located in multiple departments or buildings, eliminating the need for a costly central reference distribution system.
Fluke 732C and 734C DC Voltage Reference Standards
- RoHS compliant, direct voltage reference designed to maintain the volt in primary and secondary standards laboratories.
- 10 V, 1 V, and 0.1 V outputs, and transportable to remote locations.
- Consists of four electrically and mechanically independent 732C DC Reference Standards.
- Traceable to national standards and to the Fluke Calibration 10 V Josephson Array.
Fluke 720A Kelvin-Varley Divider
- High-resolution primary standard for ratio measurements
- 0.1 ppm of input absolute linearity, 0.1 ppm resolution, seven decades
- Temperature coefficient of linearity of 0.1 ppm/ºC
- Built-in self-calibration bridge
Fluke A40B Series Precision DC and AC Current Shunts
- Comprehensive kit with 14 low-inductance coaxial current shunts, adapters, connectors, and a rugged transit/storage case.
- Designed for currents ranging from 1 mA to 100A, intended for laboratory use in making directly measured absolute AC or DC current measurements as well as AC/DC current transfer meaurements.
- Excellent resistance value stability, a superior self-heating power coefficient, and a low temperature coefficient.
- Direct current measurement from DC to 100 kHz with a higher accuracy than previous commercially available shunt technology.